1. Knife, use gasoline or WD40 cleaner chuck and cap.

2. Clamp to the pressure cap, otherwise the tool is easy to install. If the chuck is not caught by the pressure inside the cap, the unloading clamp is clamped on the motor shaft and cannot be unloaded.

3. Pay attention to whether the chuck of the advertising engraving machine matches the selected tool before, otherwise, the tool will not fit tight.

4. Clamping tool. The protuberance of the tool clamping plate cannot be too long, or it is easy to vibrate during this process, which affects the machining quality of the workpiece surface.

5. Tools for advertising engraving machine must ensure that the spindle speed is zero, and the spindle stop state allows the removal of tools before, otherwise serious personal injury will occur.

6. If the foot press sculpture, it must be the foot press with a vacuum cleaner to clean the dust on the spindle and then clamp the tool.

7. Screw up the pressure cap in the process, and be sure to press the screw cap on the front rotor.

8. Dismount the advertising engraving machine, and use your gun to clean the pressure cap and rotor shaft garbage discharging knife after