Your Position:Home>News>Technical Support>The Maintenance Of Woodworking Engraving Machine
Contact Us






Jingdong Yanjiao East Outer Ring Road No.88, Beijing, China


  • China Wood/Advertising/Stone CNC Router Machine Manufacturers,Quality Engraving Machine Supplier

The Maintenance Of Woodworking Engraving Machine

Time:23 November 2016 Click:1088

There will be a great deal of dust in woodworking engraving machine after long term work, so we should maintain the carving machine well so that it can work for us better.


1, Computer

Computer abnormalities can cause a lot of problems, especially for the computer in connection of the engraving machine. CNC engraving machine Longdiao NC Equipment Co., Ltd. summarizes some aspects that need to notice.
Regularly kill the virus, but do not open anti-virus program while working to avoid interference.
Regularly clean chassis dust and pay attention to heat dissipation of the chassis. Do avoid industrial control card error caused by too much dust.
Regularly defragment the disk and optimize the computer system.

2, Clean up

Regularly clean the control box for dust is the biggest killer of the circuit board.
Regularly clean screw to prevent foreign body stick on the screw which is very important in the device for it determines the accuracy of the machine and it also plays an important role in the transmission process .
Clean up the table promptly after finishing work, which provides a convenient for future work.
Clean the rails and the material crumbs around the rails to prevent machine malfunction while working result from debris interference.

3, The oil

Move back and forth slowly after add the oil to ensure that lubricants can be added to the guide rail and screw.
If the machine is not used for a long time, you should regularly refuel empty to ensure the flexibility of the transmission system.
Clean up the oil and material crumbs on guide rail and screw with cloth (not hair removal). If the temperature is low, you can add oil on the guide rail and screw. The best chose is the anti-freeze oil. Refueling cycle is twice a month.


When the machine is not used, you’d better pour out the water in the tanks to prevent cracking of water tanks and water pipes on the condition that the room temperature is low.
To ensure the operating room temperature so that woodworking engraving machine can reach room temperature and the staff will not be cold.
Look at the applicable standard temperature and it should reach the minimum temperature at least.
Some users add butter to the screw and forgot to clean up in winter, which result in boot does not ran. Some studio temperature is very low, the machine can not run even with oil.

5,Cooling water

You’d better use antifreeze cooling if you can.
Note the ambient temperature and be careful to avoid water tank and water pipe cracking due to cold water. Cooling water is a necessary element for normal work of the spindle motor. If the cooling water is too dirty, it will cause serious damage to the motor. So pay attention to the cleaning of the cooling water and pump’s normal work.
Note the water level. Without water in water-cooled spindle motor, the electrical heat can not be exported in a timely manner.

Beijing Longdiao Nc Equiment Co.,LTD

Contact Us

Follow Us

  • Facebook
  • Twitter
  • Google+
  • Pinterest
  • Linkedin
  • Beijing Longdiao